This device's roles are to blanket the premise with wifi at the end of the house where the main router provides poor coverage and act as an Ethernet switch for devices in my bedroom. To give more insight to its configuration, I have it set up in bridge mode, WAN is assigned to the LAN, and I have all the cool stuff like routing and DHCP disabled, as there is already another device handling the routing and DHCP on my network. A couple months ago, I ran into a very unique situation with my Netgear WNDR3400. If you return to the LAN setting, you will see that the settings have been saved.Posted: Mon 21:01 Post subject: WNDR3400 - Bad IP - Cannot Access Interface Wait a few moments and if all goes well, you will have access to the network and to the Internet (if applicable). To begin, use a computer connected to the Netgear router and go to the address "".Įnter the default password, then go to : Advanced -> Configuration -> LAN Settings.įinally, change the IP address by the desired IP adress (for exemple : 10.0.0.1) and click "Apply."Īs stated, if the subnet mask (and therefore the IP address class) changes, you need to run a command prompt (cmd) and type the commands "ipconfig /release" then "ipconfig /renew" to, again, access the network. A small network interruption occurs during the update.Ģ. Secondary DNS and third: those of Google (for example). ![]() ![]() Primary DNS: The IP address of your parent router (where are the addresses of the DNS servers of your ISP, for example). If you want, in the "Domain name server address (DNS)", you can specify the addresses of the DNS servers that will be send to the network devices (computers, smartphones. In our case, the LAN IP address of the box, is 192.168.1.1 The IP address of the gateway is the IP address of the parent router (for exemple : the box). The subnet mask varies depending on the IP address class (IP class C : .x / Mask : 255.255.255.0, IP class A : 10.x.x.x / Mask : 255.0.0.0) Static IP address to give to your Netgear router (the IP address must be in the same class as the IP address of the gateway) In "Internet IP Address", select "Use static IP address" and enter the following information : ![]() The possibility that we will use.įor this, use a computer connected to the Netgear router and go to the address "." Go into the Netgear router to set the IP address to use. So your router will always receive the same IP address. Go into the parent router (for exemple : the box) to set a static IP address for your router. To change the WAN IP (external IP) address of the router, you have 2 options : If you connect it to a modem, the external IP address is the Internet IP address assigned by the ISP. Important : This is only possible when you connect the router on a router.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |